How can we help you? There are flashing lights on my controller and the power chair won't move. Is there anything I can do to resolve this? 1 out of 3 found this helpful Many times a brake lever reset can resolve this issue that is preventing the PWC from operating. MPV5 – The brake levers are located on the front of the Power Wheel Chair just above the footplate. To reset the brakes on the MPV5 Power Wheel Chair make sure both levers are pushed to the down position then pull one lever at a time to the full up position. TEK FWD and TEK XHD - The brake levers are located on the front of the Power Wheel Chair under the label that reads “Drive” and “Push”. To reset the brakes on the TEK FWD or XHD Power Wheel Chair make sure both levers are pushed to the down position then pull one lever at a time to the full up position. If the lights on the controller continue to flash make sure the controller is not locked. Was this helpful? Yes (1) No (1) Category: General Related Questions Do you have local repair shops that can fix my Hoveround equipment? What should I do after I try troubleshooting and my Hoveround power chair needs to be serviced? Does my insurance pay for accessories such as cup holders and side bags? Other power wheelchairs I’ve seen use solid tires, why does Hoveround use inflatable front drive tires on their chairs? How much is the PSI and how often should I check them? What happens when I get a flat drive tire? Do you sell solid, flat-free wheels?